Case Study: My Experience With Inspections

What to Do When There is Mold Infestation

There comes a time when we discover that there is mold growth in our homes, whether in the basement, attic, on the wall of our bedrooms and so forth, and of which we should deal with the situation immediately. Since the treatment could be a potential health risk, it is advisable that you get the help of a professional in assessing the mold in large areas, while the small spots of mold can be handled using DIY methods yourself.

Getting a qualified professional who will conduct a mold inspection, will help you establish the kind of mold present and the type of repairs which can be undertaken. It is also suggested that you get the best mold inspector as you can afford since this is a potentially serious situation, and thus you should not look at the cost only, especially there are many mold inspectors out there.

Mold inspection would involve identifying any condition around your property which would show mold growth, and to pinpoint problem areas like water damage, odours, signs of fungal growth and so on. The exterior of your property will also be inspected by the mold inspector aside from the interiors of your home, and the professional will check obvious signs of water damage and leaks that could come from broken gutters, or broken pipes, and so forth.

After performing the initial inspection visually, the mold inspector will then measure the moisture levels in the walls of your property. The inspector will pay special attention in areas like under the sink, around water heaters and other areas where there is a present of water, and the moisture level measurement is conducted at intervals like about two feet. In measuring the moisture level, a special meter is used, and the instrument is composed of two small pins which are inserted into the low area of the all, and then it gives a reading of the moisture level present. Note that the acceptable moisture level should be 15% or lower.

When there is growth mold observed, samples can be taken to precisely identify the type of pores present. After 3-4 days, expect the mold inspector to give you a report about the results.
It is advisable that once you have set a mold inspection, it is necessary to keep your doors and windows closed for as long as 12 to 24 hours before the inspector gets to visit. By doing this, you are making the results of the mold inspection to be as close to accuracy as possible. Detection of odours will much possible by the mold inspector because in this manner the air samples will not have a mixture of excess air from the outside.

The Best Advice on Options I’ve found

Finding Ways To Keep Up With Businesses